Non-shrink free flow cementitious grout
Polygrout NS is a cementitious non shrink grout which when mixed with water gives a free flowing shrinkage compensated grout of excellent workability and performance. Polygrout NS is a blend of selected cement, graded fillers and chemical additives. These special additives imparts controlled expansion in plastic state at the same time minimize water requirement.
Properties
- Free flowing
- Shrinkage compensated
- Premixed and properly packed to avoid site variation and errors
- Excellent bond strength to concrete and steel
- Adjustable consistency
- Impact resistant.
- Non shrink property of the grout provides maximum contact with bearing surface
- Can be used up to 80mm thickness between plate and foundation
- It is watertight and withstands chemically aggressive agents
Recommended use
Polygrout NS is a cementitious non shrink grout which can be used for the following fields:
- base plate grouting of machinery and equipment foundations
- repair of pre–cast concrete
- for anchoring of bolts, dowels etc
- sealing of tie rod holes
Step by Step
Surface Preparation
The surface should be clean, free of dust, demolding agents, oil, paint etc. Saturate the area to be grouted with water at least 24 hours prior to grouting. The surface should be damp, but strictly free of standing water. Whenever form work or shutter is used, make sure that all the joints are sealed properly to avoid grout loss.
Mixing
Mixing should be done using a drill fitted with a mixing paddle or a grout mixer. Add 2.75 - 3.25 litres of clean cool water in a container. Add Polygrout NS slowly and mix continuously for a minimum of 5 minutes to obtain a smooth, uniform lump free consistency.
Application
Grouting should be done continuously. Therefore make sure that sufficient grout is prepared before starting. While filling voids, grout should be poured from one end to avoid air pockets. the following measures shall be taken while placing the grout: – grouting operations should be preferably carried out in a shaded condition. – avoid grouting at the hottest time of the day. – place the grout within 15 minutes of mixing to obtain best results – Grouting should not be done in free & unrestrained areas as the gaseous expansion of the grout will lead to development of cracks. Polygrout NS can be poured from minimum 10mm up to 80mm in one single pour. However, for depths greater than 80mm it is recommended to add well graded aggregates of 5 to 8mm (up to 50%) to the grout in order to reduce the heat generated during the exothermic reaction when the grout is mixed and poured for larger depths. Cover the exposed areas immediately after placing with a polythene sheet, to protect from drying winds.
Yield
12.1L/25kg bag (w/p ratio of 0.12)
Mixing Proportion
Polygrout NS shall be mixed with 2.75-3.25L water at a w/p ratio of 0.12
Colour and Quantity
Grey in 25kg bag
Disclaimer
The information in this document is given to the best of Polybit's knowledge, based on laboratory testing and practical experience. Polybit's products are considered as semi-finished goods and as such, products are often used under conditions beyond Polybit's control. Polybit cannot guarantee anything but the quality of the product itself.
