Silicone Pattex SL212 - General Purpose Sealant

Application 

You will need a silicone sealant gun for application.

Surface preparation:
Surfaces must be dry, clean of dust and free of any substances which may impair adhesion.

Application procedure:
Cut off tip of spout at 45° angle, load cartridge into gun and apply steadily.

Cleaning:
Clean residue and tools with cloth

Disclaimer and Safety

Silicone-rubber compounds cannot be painted over. During hardening acetic acid is released which may cause irritation to skin, mucous membranes and eyes. Therefore ensure good ventilation. Use other building products for permanently elastic joint sealing in exposed areas, especially where chemicals are used and on substrates not listed above. Observe the warnings, safety and waste advice given in the safety data sheet.

Please not that silicone sealants are Irritating to the eyes and skin. Repeated exposure may cause skin dryness or cracking. Vapors may cause drowsiness and dizziness. Keep out of reach of children. Keep container in a well-ventilated place. Keep away from sources of ignition - No smoking. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. If swallowed, seek medical advice immediately and show this container or label.

Disclaimer 
The information in this document is given to the best of our knowledge, based on laboratory testing and practical experience. Our products are considered as semi-finished goods and as such, products are often used under conditions beyond our control. We cannot guarantee anything but the quality of the product itself.